What’s worse than a toilet that doesn’t flush? A toilet that runs all the time.
If you’ve ever had this issue, you know how frustrating it can be. The water keeps running and running, but nothing ever comes out of your bowl. It’s like being stuck in an endless loop of disappointment.
A little bit of water running from your toilet is normal. However, if the water keeps running and filling up your tank, you might have a problem. As annoying as it is to have to refill your tank every few hours, it’s even more inconvenient when you don’t know what’s causing it.
But don’t worry!
In this article, we’ll look at some of the more common reasons toilets run continuously and some tips for you on how to stop your toilet from running all the time. So you can finally get back to living your life without worrying about whether or not your bathroom will overflow again.
Why Your Toilet is Running All the Time?
As a homeowner in Paso Robles, CA, you have a lot on your plate. You need to keep up with the latest trends in home decor, you’re juggling a full-time job and a family, and you’re always looking for ways to save money.
But some things should never be sacrificed. One of those things is your toilet. You should never have to worry about whether it will run all night long—that’s just not okay! But if your toilet has been running all night long lately, here are some common causes:
1. Faulty flapper
If you’ve noticed that your toilet seems to be running more than usual, chances are that it may have something wrong with its flapper (the thing that shuts off the flow of water). If the flapper is not working properly, this could cause excess water pressure in the tank and make it seem like the toilet is constantly running. It’s essential to replace this part as soon as possible!
2. Your fill valve is leaking or broken
The fill valve regulates how much water goes into your tank when you flush; if it needs replacing, fix that problem before trying anything else because none of your other fixes will matter without a working fill valve!
3. Defective overflow tube
The overflow tube is the piece that lets water out of your tank when it fills up, and it can get clogged or broken. This can cause an overflow in your toilet bowl, so you’ll want to check this first if your toilet keeps running.
4. Malfunctioning flush handle or chain
If your handle or chain is loose or broken, it may cause the flapper to stay open longer than necessary, allowing water to flow continuously into the bowl. You can easily fix this problem by replacing your flapper with a new one!
Things You’ll Need To Fix toilet running all the Time
Here are some things you’ll need to fix your toilet from running all the time (Your toilet repair kit):
-A plunger (to unclog any obstructions in your pipes)
-A wrench (to tighten any loose nuts or bolts on the underside of your toilet)
-A bowl brush (to clean out any debris in the bowl that may be causing leaks)
-A bucket or bowl to catch the water while you’re waiting for it to stop running
-A screwdriver to remove the lid from the overflow tube in case it gets clogged with debris
-Float
-Flapper
-Flush valve
-Towel, cloth, or sponge
DIY Toilet Repair Tips
The toilet is a staple of the home. It’s like a toothbrush or a shower: you shouldn’t have to think about it, you just expect it to be there for you every time you need it, and it always delivers.
But all too often, when we think about our toilets, we think about how much they cost to repair or replace. The truth is that even if you have a brand-new toilet with all the bells and whistles, you can still find yourself dealing with clogs, leaks, and other plumbing problems.
So before you call in an expensive Paso Robles, CA plumber, try one of these DIY tips to save money on toilet repairs:
If your toilet bowl is stained, try this trick.
Take an old toothbrush and some baking soda, and scrub the stains away! The baking soda will help loosen up any dirt or grime that’s stuck in there and scrub it out without damaging the porcelain finish on your toilet bowl.
Make sure to Check for Leaks.
If your toilet is leaking water from under the tank or from the base of the bowl, this is probably due to a leaky flapper or flush valve seat. These problems can often be easily fixed by replacing worn parts or fixing damaged seals with an O-ring kit.
Replace Flush Valve Seal Gasket
If your toilet won’t stop running until you jiggle the handle or turn off the water supply valve after flushing, it’s possible that your flush valve seal gasket needs replacement. This gasket helps keep water from escaping out of the bottom of your tank as pressure builds up during flushing operations. If it breaks down completely, water will continue flowing until someone seals it.
Adjust Your Flapper
If your toilet keeps running, that could mean that your flapper is not properly adjusted. The flapper allows water to enter the tank when it’s flushed but needs to be able to seal off again so that water doesn’t keep draining out after each flush. To adjust the flapper, first turn off the water supply to the toilet by turning off the valve under or behind the bowl (you should be able to see where this is). Then remove the cap of your tank and inspect how much space there is between the ballcock (the arm at the bottom of your toilet tank) and its seat. Adjusting this gap will help you stop any leaks from happening in your tank.
Plunging
Wear rubber gloves and place a bucket under the drain opening in your toilet bowl for toilet flange repair. Use a plunger to push down on the clogged area of your toilet until water drains into the bucket below. You may have to repeat this process several times until all the water has been removed from your toilet bowl.
Address Overflow Tube Issues
One common cause of leaks is an overflow tube that’s not functioning properly. The tube allows water to flow into the bowl when you flush and then discharges excess water back into the tank after flushing. If this tube is clogged with debris or doesn’t fit snugly in its hole, then there will be no place for the water to go after flushing, so it will simply run down onto your floor!
Fixing Problems With The Flush Handle Or Chain
If your toilet isn’t flushing properly, it could be because something has come loose inside your tank or bowl. A loose handle or chain can cause problems with both flushing and refilling—that’s why we always recommend checking them first when diagnosing a leaky toilet! If either of these parts is damaged or missing, then replacing them will solve your problems quickly and easily.
If your toilet has clogged up with too much stuff (and not enough water), try this.
Find the drain pipe under your sink or behind the commode itself and pour some Drano down until you see some bubbles coming up through the pipe—that means it’s working! Let it sit for 30 minutes before repeating if necessary (you may need to do this multiple times).
Repairing A Broken Handle
If your toilet handle breaks off, don’t worry—you can replace it easily with an adjustable wrench and some plumber’s tape. Wrap some tape around the base of the handle where it connects with the pipe just below where it broke off (it should be easy to see where this happens). Then use an adjustable wrench to slide off the nut from under your old handle and slide on a new one—it will fit perfectly!
Call Emergency Plumbing Services in Paso Robles!
If you have tried all of the DIY toilet repair tricks and your toilet is running all the time, it’s time to call Emergency Plumbing Services in Paso Robles!
That’s right; we know how frustrating it can be when your toilet keeps running. You’re busy, don’t want to deal with it, and just want to get on with your life. But if you keep ignoring the problem, it will only get worse.
That’s why Rocksteady Plumbing offers 24-hour emergency plumbing services in Paso Robles. Our plumbers are certified by the State of California and have over 10 years of experience. We use only the highest quality parts for your repair or installation. And if something goes wrong after our work is done, we’ll come back at no charge—for as long as you own your home!
When you call us for Emergency Plumbing Services in Paso Robles, we will send out one of our skilled plumbers as quickly as possible. Think of us as a partner in your home maintenance projects: we’ll help guide the way when too many variables are involved for us to do everything by ourselves!
We don’t simply want to prevent the problem from occurring again; we want to repair it so that it never does.
If you want a plumbing company that will treat you like family and makes sure that your home runs smoothly again, then Rocksteady Plumbing is the place for you. Call us at 805-237-7625 for emergency plumbing services in Paso Robles, CA!
